Printed transmissions and joint arrangement
Thor uses a yaw–roll–roll–yaw–roll–yaw layout driven by stepper motors. Printed gears and GT2 belts mean gear backlash, pulley alignment and belt tension influence the behavior of the assembled arm.
Unlike a single ready-made mesh collection, the main repository includes editable FreeCAD designs and interchange STEP files, so parts can be modified before a new STL is exported.
Selecting the right assembly instructions
Read the official printing guide before slicing parts. The separate assembly walkthrough shows axis-by-axis installation; electronic setup is another document and must match your control board.
Small dimensional changes in printed gear teeth or bearing pockets can affect entire joints. Inspect individual axes with the controller unpowered before combining them.
From firmware to ROS 2
The project's control ecosystem includes an Arduino Mega-compatible control shield, Asgard motor software and a ROS 2/MoveIt 2 integration. They are separate components, not one automatically configured install.
Before trying a ROS trajectory, confirm low-level direction, home offsets and motor travel independently. The ROS configuration cannot compensate for incorrect assembly or a mismatched controller pinout.
Thor FreeCAD models, STL parts and gearbox assembly
Use matching revisions of parts, firmware and instructions. These steps summarize project documentation; no physical build was performed for this article.
Official files and manuals 5 references
Assembly sequence 5 steps
Select a hardware and controller configuration
Check the official BOM and decide between the DIY PCB or supported commercial electronics.
Manufacturer's instructions ↗Print the matched geometry
Export or download the STL set for that revision and test-fit gears, bearings and pulleys.
Manufacturer's instructions ↗Assemble the axes
Work from the base outward using the mechanical guide; inspect gear and belt alignment at each joint.
Manufacturer's instructions ↗Wire and flash
Choose the firmware matching the specific board, follow the wiring diagram and verify motor phases.
Manufacturer's instructions ↗Home and test
Test low-speed travel and homing without a tool or payload; then configure higher-level control.
Manufacturer's instructions ↗
Gear interference, ROS 2 and historical budget
Answers are based on published source material and project documentation. Their order does not represent search volume.
01Where can I download Thor STL and editable CAD files?
The official repository has separate stl, step and freecad-src directories. Use one revision across those files to avoid mixing incompatible gear geometry.
Sources Official project documentation ↗
02Can Thor lift 750 g at the wrist?
The maintainer's figure is up to 750 g including the end effector. It is not an independent continuous-duty or full-reach certification.
Sources Official project documentation ↗
03Why does a joint skip steps or feel tight?
Inspect printed gear interference, pulley alignment and GT2 belt tension. Only then check firmware acceleration and step configuration; the mechanical and electrical guides address different causes.
Sources Official project documentation ↗
04Can I control Thor with ROS 2?
The creator links a separate Thor-ROS project with ROS 2 and MoveIt 2 support. Confirm that your low-level board and firmware match its expected hardware.
Sources Official project documentation ↗
05Is the €350 price guaranteed?
No. It is the project's published hardware-cost claim. Compare today's motor, bearing, material, shipping and electronics prices using the BOM.
Sources Official project documentation ↗
What to check before building Thor Robot Arm
Build and integration
Choose a Thor mechanical revision, print the stl meshes, buy the bearings, belts, steppers and fixings from the matching BOM, then follow the assembly guide. Check GT2 belt tension and gear engagement before loading motor firmware. Match your control electronics to the relevant wiring guide.
Known constraints
The reported 750 g figure includes the end effector and comes from the project; no independent payload test was performed. Build cost under €350 is a creator estimate rather than a current market quote. Different driver boards require different firmware and wiring.
Original documentation
Found a changed specification? Submit a correction with its source ↗